Ok I am working on some of my very simple inventions and other simple inventions that can be used to be able to be put in a jungle and do more than just survive but be able to make a simpler easy living ..I hope that by the time I am done i will have full working knowledge on building a simple home and having running water bathrooms and ya even electricity/heat ..
the new one i just thought of was what if you do not have a river or stream of running water how do you make a dynmo work ..what about windmill with no wind? solarpanel with out sun for days..tho solar panels and dynamos are not basic to make as and ya, i would want to be able to make them from scratch if possible I will by the parts or the whole dynamo for electricity..this is an idea I want to use compressed air to rotate the "fan" of the dynamo or even power generator instead of using fuel or or running water..m idea is to take or make a big container and have a lid in the middle of the container(does not need to be precise middle just an example) with the lids outer edge lightly touching around the whole outer circumference of the lid to the inside wall of the container ..under the lid are springs that are strong enough to keep the lid held in the middle of the container ..now you are near a lake so you do need a water source tho you could use dirt if need be cuz we want compressed air..you ciphen water from the lake with a sizable hose length and width and let it begin filing the container now near the bottom of the container you have holes with attached hoses sticking out as the lid begins to side down the inside of the container the air will be forced out by the weight of the water filling on top of the container..you can attach the dynamo to this hose..build a case for the dynamo so the air can be thoroughly used to spin the dynamo..this should produce electricity..I am working on a "trick" when the lid reaches near the bottom of the lid I want there to be something that will release all the water from the container so that the springs under the lid will push the lid back in place while at the same time the exit for the water will be shut off and the process will repeat and i am working on a way to harness the water that gets dumped out to be focused into more power again i just came up with this so I need time to get it sorted out..and also anything that needs to be spun by electricity ..be it tools up to generators this I believe can do the trick..
Make a free website with Yola